Boiler and heating FAQs
Straight answers from Pete, answer first. Can't find yours? Call (435) 800-5047.
No questions match that search. Call (435) 800-5047 and ask Pete directly.
Boilers and repairs
Why is my boiler not heating?
The usual causes are low system pressure, a failed circulator pump, a stuck zone valve, air in the lines, or an ignition or control fault. An error code points to the part. We test each one and show you the cause before we quote.
Boiler repair →What should I do if there's no heat in my house?
Check that the thermostat is set to Heat and above room temperature, then look at the boiler for an error code or low pressure. If you smell gas, leave and call 911 from outside. Otherwise call us at (435) 800-5047.
Emergency boiler repair →Why is my boiler losing pressure?
Usually a leak, a failing expansion tank or a relief valve letting water out. A small drop right after bleeding air is normal. If pressure keeps falling, book a check before the boiler locks out.
Boiler repair →Why is my boiler making banging noises?
Banging, often called kettling, is usually scale or sludge on the heat exchanger making water flash to steam, or air in the pipes. Kettling can damage a boiler, so book a check.
Boiler maintenance →Can a leaking boiler be repaired?
Often, yes, if the leak is at a fitting, valve or pump. A leak from the heat exchanger usually means it's time to price a new boiler.
Boiler replacement →Do you repair boilers you didn't install?
Yes. We repair most brands, whoever installed them, including discontinued boilers when parts can be found.
Booking and service area
What areas do you serve?
25 towns across Salt Lake, Summit and Wasatch counties, from Herriman to Coalville, including Park City, Heber City and Midway.
Areas we serve →What are your hours?
Monday to Friday 8 am to 6 pm, and Saturday 9 am to 2 pm. Emergency service is available.
Contact us →Do you work on commercial buildings?
Yes. Recent jobs include a high-pressure steam boiler at a Midvale brewery and commercial water heaters.
Do you work on furnaces and air conditioners?
Yes, we repair furnaces and AC. Boilers and hydronic heat are our focus.
Costs and rebates
How much does boiler repair cost?
Common repairs typically run $250 to $1,000. A heat exchanger or control board can cost more. You get a written price before we start.
Boiler repair cost →How much does a new boiler cost in Utah?
Most boiler replacements cost $4,500 to $11,000. Size, zones, venting and whether it also heats a driveway or water tank set the price.
Boiler installation →How much does a boiler tune-up cost?
A standard tune-up typically runs $150 to $300. Add-ons, like a heat exchanger cleaning, are priced before we do them.
Boiler maintenance →How much does radiant floor heating cost?
New hydronic systems typically run $8 to $18 per square foot for the tubing, manifold and controls. A new boiler or heat pump, if you need one, is extra.
Radiant floor heating →How much does a heated driveway cost?
Hydronic snowmelt typically runs $20 to $40 per square foot, plus the boiler if the area needs its own.
Heated driveways →Are there rebates for a new boiler in Utah?
Enbridge Gas Utah's ThermWise program offers rebates on some high-efficiency boilers. Amounts and rules change, so we check the current list with you before you buy.
Radiant floors and snowmelt
How does radiant floor heating work?
Warm water runs through PEX tubing under the floor. A boiler or heat pump heats the water, a manifold sends it to each zone, and a thermostat in each room controls the heat.
Radiant floor heating →Can radiant heat go under hardwood?
Yes, with the right design. Hardwood needs lower water temperatures and a mixing valve to protect the wood.
Why is one room cold when the rest are warm?
Usually a zone valve, a thermostat or air in that loop. Our guide walks through all six common causes.
Read the guide →How does a snowmelt system work?
A boiler heats a glycol mix, pumps send it through tubing under the drive, walks or steps, and a snow sensor turns it on when snow falls.
Heated driveways →Do snowmelt systems need maintenance?
Yes. Plan on a check each fall. Glycol breaks down over time, and pumps and sensors wear out.
Maintenance and replacement
How often should a boiler be serviced?
Once a year, best in late summer or early fall. High-efficiency boilers also need a heat exchanger cleaning from time to time, and snowmelt boilers should be checked every fall.
Boiler maintenance →How long does a boiler last?
Most boilers last 10 to 15 years with yearly service. Some last longer.
When should I replace my boiler instead of repairing it?
When it's 15 years or older and needs a major repair, keeps breaking, or the heat exchanger is cracked. We price both so you can compare.
Boiler replacement →Do you offer a maintenance plan?
Yes. Our prepaid plan covers your yearly tune-up and gets you on the schedule before the fall rush.
Maintenance plan →How long does a boiler replacement take?
Most boiler swaps take one to two days. Jobs with new venting, more zones or a second boiler can take longer.
Heat pumps, water heaters and water
Can a heat pump run radiant floors?
Yes. An air-to-water or geothermal heat pump heats water, the same job a boiler does, and radiant floors suit the low water temperatures heat pumps make.
Heat pumps →Do heat pumps work in Utah winters?
Yes, with the right design. An air-to-water unit puts out less heat as it gets colder, so we often pair it with a boiler. Geothermal stays steady all winter.
Should I repair or replace my water heater?
Repair it if it's under about 8 years old and a part has failed. Replace it if the tank leaks or it's more than 10 to 12 years old.
Water heaters →Do I need a water softener in Salt Lake City?
If you see white scale on faucets or spots on dishes, your water is likely hard. A simple water test tells you for sure.
Water treatment →Does hard water damage a boiler?
It can. Scale builds up on the hot water side of combi boilers and water heaters. We test boiler water and treat the loop to stop scale and corrosion.