Boilers
Lockouts, error codes, ignition faults and leaks. Wall-hung condensing boilers and older cast iron.
- Error codes and lockouts
- Ignition and burner faults
- Condensate traps and drains
Serving the Salt Lake Valley, Park City, Heber and Midway
No heat, a leak or an error code? We find the cause, give you a written price, then fix it. We work on most boiler brands.
The usual causes are low system pressure, a failed circulator pump, a stuck zone valve, air in the lines, or an ignition or control fault. An error code points to the part. We test each one and show you the cause before we quote.
No heat in a Utah winter puts your pipes at risk. Call and we'll talk you through what to check while we head your way.

We start with what you see. Then we test the boiler and the system around it until we find the part that failed.
You get the cause and a written price before we fix anything. If a repair doesn't make sense on an older boiler, we'll tell you.
A cold room isn't always the boiler's fault. We fix the whole hot water system.
Lockouts, error codes, ignition faults and leaks. Wall-hung condensing boilers and older cast iron.
When one room or one floor goes cold, the cause is often a pump or a zone valve.
Your boiler may also run radiant floors, a snowmelt system or an indirect water heater. We work on all of it.
Most repairs come down to one part and the time to replace it. Common repairs typically run $250 to $1,000. A heat exchanger or control board can cost more.
You get the price in writing before we start.
| Repair | What drives the price |
|---|---|
| Zone valve | A low-cost part. Most of the bill is labor. |
| Circulator pump | Depends on the pump size and brand. |
| Ignition or flame sensor | Small parts that wear out over time. |
| Control board | One of the pricier parts. Boards for older boilers can be hard to find. |
| Heat exchanger | The biggest repair. On an older boiler, a new boiler may cost less over time. |
Every brand here is from a recent job. In September we tracked down a part for a discontinued Triangle Tube boiler in Park City.
From Pete's field log. Each post lists the job and the parts.

The boiler sent the wrong temperatures to parts of the home. We updated and calibrated the controls.

We fixed a leaking manifold and found old polybutylene fittings. We suggested an upgrade before they fail too.

A Triangle Tube boiler needed a condensate trap that is no longer made. We found one and fixed it.

A failed zone valve cut heat to part of the house. We serviced the zone valves and the heat came back.
“Thank you Boiler Buzz for getting back to my voicemail so fast and coming out to fix my boiler system!”
We treat no-heat calls as urgent. Call (435) 800-5047 for today's schedule.
Often, yes, if the heat exchanger is sound. Most boilers last 10 to 15 years. If yours is older and has a major failure, we'll price a repair and a replacement so you can compare.
Yes. We repair most brands, whoever installed them.
It points to the part that tripped, like ignition, water flow or a sensor. Write it down or take a photo, and include it when you book.
Yes. We service steam boilers in homes and businesses, including a high-pressure steam boiler at a Midvale brewery.
We repair boilers in 25 towns across Salt Lake, Summit and Wasatch counties, all from our base in West Jordan.