Heated driveways and snowmelt systems in Park City
Serving the Salt Lake Valley, Park City, Heber and Midway
We install, repair and service hydronic snowmelt for driveways, walkways and steps. Your drive clears itself, so you can put the shovel and the salt away.
What is a snowmelt system?
A snowmelt system heats a driveway, walkway or steps from below. A boiler warms a glycol mix. Pumps send it through tubing set in concrete or under pavers. A snow sensor turns it on when snow falls, and the surface stays clear.
01 · Snow sensorSenses snow and cold, then calls for heat. No switch to flip.
02 · BoilerHeats a glycol and water mix. Large drives usually get their own boiler.
03 · Pumps and manifoldPush warm glycol into each loop at the right flow.
04 · Tubing in the slabPEX loops under concrete or pavers melt snow as it lands.
A new system, a repair or a pre-winter check
New installation
For new builds and driveway replacements. We size the boiler, lay out the loops and pressure-test the tubing before the concrete goes in.
Driveways, walkways, steps and patios
Dedicated snowmelt boilers
Snow sensors and automatic controls
Repair
For a system that melts in stripes, stops melting or trips the boiler. We trace it to the boiler, a pump, the glycol, the sensor or a leak.
Boiler lockouts and error codes
Failed pumps and zone valves
Sensor and control repair
Pre-winter service
A fall check before the first storm. We test the glycol, clean the boiler, and run the pumps and sensor.
Glycol strength test
Boiler clean and combustion check
Pump and sensor test
Signs your snowmelt needs service
It melts in stripes or patches
A light snow takes hours to clear
The boiler locks out during storms
System pressure keeps dropping
The sensor does not turn it on
No one has tested the glycol in years
How much does a heated driveway cost?
It depends on the area, the surface and the boiler. Most systems are priced per square foot. Hydronic systems typically run $20 to $40 per square foot, plus the boiler if the area needs its own.
We measure on site and give you a written quote. No guesses over the phone.
Factor
Why it matters
Area
More square feet means more tubing and a bigger boiler.
Surface
Concrete and pavers each install a different way.
Boiler
Sharing a home boiler costs less. A large drive needs its own.
Controls
A snow sensor and idle mode cost more and melt sooner.
Tear-out
An existing driveway has to come out before tubing goes in.
From site visit to first storm
1Site visitWe measure the area and look at your boiler and gas line.
2Layout and quoteYou get a loop layout and a written price.
3Tubing and testWe lay the tubing and pressure-test it before the pour.
4Boiler and controlsWe set the boiler, pumps, glycol and sensor.